Battery replacement

 

The battery of the Zimmer has been a puzzle over the years. Some have it under the driver side fender, some in the trunk. Ours is in the trunk

(This is a Zimmer mod)

Of course it does not really matter where the battery is located. But I thought it was a very dangerous situation. When I bought the Zimmer, it came with a new battery, but the technician had one mounted with the poles below the steel trunk support of the original Mustang.

If you take a close look, the PLUS pole is located less than a mm from the steel body part. And having only a strap to secure the battery to the bottom of the trunk, it is reasonable to expect an explosion when we hit a bump and the battery jumps just one millimeter. 





So first thing I did was to put some self made insulation between PLUS and Body. This gave me some safe feelings while driving, but it was not the final solution. 


Also, the ground cable was not even 1/3 of the diameter of the mains. Funny this, what goes out, must come back in yes ?

So I replaced the ground with a big good cable and put a circuit breaker in between.







The new battery has the poles on the other long side (you can not just turn the battery 180 degrees, as the cables will not fit in that position) and as such, way out of the body reach!

And the Zimmer battery cover, that will also have room for a danger sign and a tool kit :-) 




Reacties

Een reactie posten

Populaire posts van deze blog

Headlight Rewiring

Afbeelding
A Zimmer Golden Spirit is for most owners a pretty old car, lasting between approx. 50 and 30 years. Only the very rich among us can afford to have a new Zimmer build for them. And old cars suffer from : ... bad wiring ! (This is a Zimmer mod.) Our #620 sufferd great at the headlight section. One day we would have 2 dim lights, the other day we would have only one high beam. Or worse, no Dim but 2 High beam. Also the fog lights would or would not come up, not to speak of the city lights that might run on 1/25th of power on the right side and full on the left... .  So first I started to completely rewire the Dim/High beam for the H4 bulbs.    While diagnosing the problems, I noticed that all H4 wiring was running through the steering column, apparently, as there were no relays in the Mustang Service manual electrical diagrams. So I started designing a safe , fused and relayed circuit.  I used 2 relays,  Rel#1 gets its trigger from the main lights switch, if pulle...
Meer lezen
Afbeelding
The significant horns on the Zimmer were not operational.  After fixing them, I modified the controls so I could operate them from the Nardi wheel!                                                                                      This is a Zimmer mod. First, the idea is to use paddles to operate the horns.  However, turning the wheel will clash additional cables, so I designed a set of wireless paddles. The paddles, I designed and printed on my 3D printer. I designed them to contain a 'remote' from a cheap Ali-express remote relais set.  The left paddle operates one relay, the richt paddle operates another.  The tension of the remote buttons is enough to push the paddle back after usage. The receiver will be moun...
Meer lezen